Engine Mechanical: 1D-54
• Tighten the gear position switch mounting bolts.
CAUTION
!
• Be careful not to tighten the bolts too
much.
• Clamp the read wire firmly.
Oil Gallery Plug
Install the oil gallery plug to the specified torque.
CAUTION
!
Use a new gasket (1) to prevent oil pressure
leak.
Tightening torque
Main oil gallery plug (a): 18 N·m (1.8 kgf-m, 13.0 lb-
ft)
Oil Jet
When installing the oil jet, apply grease to the O-ring.
CAUTION
!
Use a new O-ring to prevent oil pressure leak.
Automatic Transmission
• Install the automatic transmission component parts
(1). Refer to “V-belt Type Continuously Variable
Automatic Transmission Removal and Installation in
Section 5A (Page 5A-5)” and “Clutch Shoe Removal
and Installation in Section 5A (Page 5A-16)”.
Crank Balancer Drive / Driven Gear
• Install the pin (1).
(a)
I831G1140261-03
1
(a)
I831G1140339-01
I831G1140262-01
1
I831G1140263-01
1
I831G1140264-02
To Next Page
Loading...
