Engine Mechanical: 1D-56
• Apply thread lock to the balancer driven gear bolts.
: Thread lock cement 99000–32030
(THREAD LOCK CEMENT SUPER 1303 or
equivalent)
• Hold the crank balancer drive gear nut with the special
tool and tighten bolts to the specified torque.
Special tool
(A): 09924–52460 (Socket (52 mm))
Tightening torque
Crank balancer driven gear bolt (a): 50 N·m (5.0
kgf-m, 36.0 lb-ft)
Oil Pump
• Apply thread lock to the oil pump mounting bolts and
tighten the bolts.
: Thread lock cement 99000–32050
(THREAD LOCK CEMENT 1342 or equivalent)
• Install the washer (1) and pin (2).
• Install the oil pump drive gear (3) with chain (4).
• Install the snap ring (5).
NOTE
Be careful not to drop the snap ring (5) into
the crankcase.
Cam Chain Tensioner
• Install the cam chain tensioner (1) along with the
washer (2).
• Tighten the cam chain tensioner bolt (3) to the
specified torque.
Tightening torque
Cam chain tensioner bolt (a): 23 N·m (2.3 kgf-m,
16.5 lb-ft)
Transfer Output Drive Gear
• Install the spacer (1) and (2).
(A)
(a)
I831G1140271-02
(A)
(a)
I831G1140272-01
1
2
I831G1140273-01
3
4
5
I831G1140274-01
1
2
(a)
3
I831G1140275-01
1
2
I831G1140276-01
To Next Page
Loading...
