1D-57 Engine Mechanical:
• Install the snap ring (3).
CAUTION
!
The removed snap ring must be replaced
with a new one.
Special tool
: 09900–06107 (Snap ring pliers)
Gearshift System
• Install the gearshift cam stopper (1), bolt (2), washer
(3) and return spring (4).
NOTE
Hook the return spring end “A” to the
stopper (1).
• Check the gearshift cam stopper moves smoothly.
• Locate the gearshift cam in the neutral position.
• Install the gearshift cam stopper plate (5).
NOTE
Align the gearshift cam pin “B” with the
gearshift cam stopper plate hole “C”.
• Install the gearshift shaft (6).
NOTE
Align the punch mark “D” with the concave
mark “E” of gearshift cam of surface.
Starter Driven Gear
• Install the starter driven gear (1) and key (2).
3
I831G1140277-01
1
2
3
4
I831G1140278-01
1
“A”
I831G1140279-02
5
“C”
“B”
I831G1140280-01
6
“D”
“E”
I831G1140282-01
1
2
I831G1140323-01
To Next Page
Loading...
