Transfer: 3C-15
6) Remove the following parts from the gearshift shaft
(4).
• Gearshift return spring (5)
• Shift gear (6)
• Snap ring (7)
Special tool
: 09900–06107 (Snap ring pliers)
7) Remove the gearshift cam stopper plate (8).
8) Remove the gearshift cam stopper (9).
Installation
Install the gearshift shaft and gearshift cam plate in the
reverse order of removal. Pay attention to the following
points:
• Install the gearshift cam stopper (1), bolt (2), washer
(3) and return spring (4).
NOTE
Hook the return spring end “A” to the
gearshift cam stopper.
CAUTION
!
Make sure that the gearshift cam stopper
moves smoothly.
• Tighten the gearshift cam stopper bolt (2) securely.
• Check the gearshift cam stopper moves smoothly.
• Locate the gearshift cam in the neutral position.
7
5
6
4
I831G1330050-03
9
8
I831G1330062-02
1
2
3
4
I831G1330051-01
2
“A”
I831G1330052-02
To Next Page
Loading...
