Suzuki LT-A750X/P - Page 412

3C-16 Transfer:
• Install the gearshift cam stopper plate (5).
NOTE
• Align the gearshift cam pin “B” with the
gearshift cam stopper plate hole “C”.
• Tighten the gearshift cam stopper plate bolt securely.
• When installing the shift arm return spring, position
the stopper “D” of gearshift shaft No. 2 and stopper
“E” of shift gear between the return spring ends “F”.
• Install the snap ring (6) and washer (7).
CAUTION
!
the removed snap ring (6) must be replaced
with new one.
• Install the gearshift assembly by aligning the punch
mark “G” of shift gear with the match mark “H” of
gearshift cam stopper plate.
• Install the generator cover. Refer to “Generator
Removal and Installation in Section 1J (Page 1J-4)”.
• Pour engine coolant and engine oil. Refer to “Cooling
System Inspection in Section 0B (Page 0B-15)” and
“Engine Oil and Filter Replacement in Section 0B
(Page 0B-10)”.
“B”
“C”
5
I831G1330053-02
5
I831G1330054-02
“F”
“D”
“E”
I831G1330055-01
6
7
I831G1330056-01
“G”
“H”
I831G1330057-03