Automatic Transmission: 5A-7
Fixed drive face
Remove the fixed drive face (1).
Installation
Install the automatic transmission component parts in
the reverse order of removal. Pay attention to the
following points:
Fixed drive face
Install the fixed drive face (1).
CAUTION
!
Degrease the fixed drive face. Use
nonflammable cleaning solvent to wipe off
oily or greasy matter and make its surfaces
completely dry.
Movable driven face / drive V-belt
• Install the drive belt (1), as low as possible, between
the movable driven face and fixed driven face by
tapping with a plastic mallet.
CAUTION
!
• The drive belt should be installed so that
the arrows on the drive belt periphery
point in the normal turning direction.
• The drive belt contact surface of the driven
face should be thoroughly cleaned.
• Apply grease in the groove of fixed driven face.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
• Install the movable driven face assembly (2).
CAUTION
!
Pull the center area “A” of upper and lower
belt lines to be close to each other to prevent
the belt from expanding.
1
I831G1510014-01
1
I831G1510014-01
1
I831G1510015-01
I831G1510016-01
2
“A”
I831G1510017-01
To Next Page
Loading...
