5A-8 Automatic Transmission:
• Tighten the movable driven face bolt (3) to the
specified torque with the special tool.
Tightening torque
Movable driven face bolt (a): 110 N·m (11.0 kgf-
m, 79.5 lb-ft)
Special tool
(A): 09930–40113 (Rotor holder)
Movable Drive Face
• Install the movable drive face assembly (1).
CAUTION
!
Degrease the movable drive face assembly
(1). Use nonflammable cleaning solvent to
wipe off oily or greasy matter and make its
surfaces completely dry.
• Install the collar (2) and movable drive face bolt (3).
NOTE
The deep concave of the collar (2) faces
outside.
• Install the dowel pins (4).
• Install the movable drive face cover (5).
• Tighten the movable drive face bolt (6) to the specified
torque with the special tool.
Tightening torque
Movable drive face bolt (a): 110 N·m (11.0 kgf-m,
79.5 lb-ft)
Special tool
(A): 09930–40113 (Rotor holder)
NOTE
Turn the fixed drive face until the belt is
seated in and driven faces will move together
smoothly without slip.
• Install the cap.
(A)
(a)
3
I831G1510018-01
1
I831G1510019-01
2
3
4
4
2
3
I831G1510020-02
5
I831G1510021-01
(A)
(a)
6
I831G1510022-01
To Next Page
Loading...
