5A-12 Automatic Transmission:
4) Loosen the special tool handle slowly and remove
the special tool.
5) Remove the spring plate (3) and spring (4).
6) Remove the spring seat (5) and O-rings (6).
7) Remove the pins (7) and rollers (8).
8) Remove the movable driven face (9).
9) Remove the oil seals (10) and (11) from the movable
driven face.
NOTE
If there are no abnormal conditions, the oil
seals removal are not necessary.
Assembly
Assemble the movable driven face in the reverse order
of disassembly. Pay attention to the following points:
• Install the oil seals with the special tool.
Special tool
(A): 09913–70210 (Bearing installer set)
CAUTION
!
The removed oil seals must be replaced with
new ones.
3
4
I831G1510037-01
6
6
5
I831G1510038-01
7
8
I831G1510039-01
9
I831G1510040-01
11
10
I831G1510041-01
(A)
(A)
I831G1510042-01
To Next Page
Loading...
