Automatic Transmission: 5A-13
• Install the O-rings (1) to the movable driven face.
• Apply grease to the oil seal lips, O-rings and inside
groove of movable driven face.
CAUTION
!
Replace the O-rings (1) with new ones.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
CAUTION
!
• Wipe off any excess grease thoroughly.
• Take care not to apply grease to the
contact surface of the drive belt.
• Install the movable driven face (2) to the fixed driven
face (3).
• Apply grease to the pin grooves of the movable driven
face.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
CAUTION
!
To prevent damaging the oil seal lip from
during installation, slide the lip using a 0.1-
mm steel sheet as a guide.
• Install the rollers (4) and pins (5).
• Install the spring seat (6) aligning the hole “A” with the
hole “B”.
• Install the spring (7) and spring plate (8) by aligning
the spring ends with the holes.
1
I831G1510043-01
2
3
I831G1510116-01
5
4
I831G1510044-02
6
“A”
“B”
I831G1510045-01
7
8
I831G1510046-01
To Next Page
Loading...
