Suzuki LT-A750X/P - Page 630

Brake Control System and Diagnosis: 4A-5
• Install the rear brake pedal shaft (1) and tighten the
brake pedal shaft nut (2) to the specified torque.
Tightening torque
Rear brake pedal shaft nut (a): 60 N·m (6.0 kgf-m,
43.5 lbf-ft)
• After installed rear brake cable, adjust the adjuster
nut. Refer to “Rear Brake Pedal / Rear Brake (Parking
Brake) Lever Inspection and Adjustment in Section 0B
in related manual”.
• Install the removed parts.
Specifications
Tightening Torque Specifications
B931G44107002
NOTE
The specified tightening torque is described in the following.
“Front Brake Hose Routing Diagram (LT-A750XP/ZK9) (Page 4A-1)”
“Rear Brake Pedal Construction (LT-A750XP/ZK9) (Page 4A-3)”
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque List (LT-A750XP/ZK9) in
Section 0C (Page 0C-7)”.
Special Tools and Equipment
Recommended Service Material
B931G44108003
NOTE
Required service material is also described in the following.
“Rear Brake Pedal Construction (LT-A750XP/ZK9) (Page 4A-3)”
1
(a)
2
I931G3410007-01
Fastening part
Tightening torque
Note
Nm kgf-m lbf-ft
Brake pipe flare nut 16 1.6 11.5 ) (Page 4A-2)
Rear brake pedal shaft nut 60 6.0 43.5 )(Page 4A-5)
Material SUZUKI recommended product or Specification Note
Grease Water resistance grease or
equivalent
P/No.: 99000–25160 )(Page 4A-4) / )(Page 4A-
4)