3-30 ENGINE
! Valve spring tension (IN. & EX.)
Standard INNER : 76 – 90 N/32.5 mm
(7.8 – 9.2 kgf/32.5 mm)
OUTER: 186 – 219 N/36.0 mm
(18.9 – 22.3 kgf/36.0 mm)
CAM CHAIN TENSIONER
Inspect the cam chain tensioner for damage. If any damage are
found, replace the cam chain tensioner with a new one.
REASSEMBLY
Reassemble the cylinder head in the reverse order of disassem-
bly. Pay attention to the following points:
• Install each valve spring seat
1.
• Apply molybdenum oil solution to the valve stem seal
2, and
press-fit the seal into position by hand.
"
# MOLYBDENUM OIL SOLUTION
• Apply molybdenum oil solution to the valve stems.
"
# MOLYBDENUM OIL SOLUTION
Do not reuse the valve stem seals.
When inserting each valve, take care not to damage
the lip of the stem seal.
To Next Page
Loading...
