ENGINE 3-51
NOTE:
Two kinds of gearshift forks (
A,
B) are used. They resemble
each other very closely in external appearance and configura-
tion. Carefully examine the illustration for correct installing posi-
tions and directions.
CRANKCASE
• Wipe both crankcase mating surfaces with a cleaning solvent.
• Apply SUZUKI BOND uniformly to the mating surface of the
right crankcase and assemble the cases within a few minutes.
+ 99104-31140: SUZUKI BOND “1207B”
• Install the dowel pins into the left half of the crankcase.
• Apply engine oil to the conrod big end and transmission
gears.
• Tighten the crankcase bolts to the specified torque.
# Crankcase bolt: 11 N·m (1.1 kgf-m)
• Install the clamp to the bolt
A.
To Next Page
Loading...
