3-52 ENGINE
NOTE:
* After the crankcase bolts have been tightened, make sure that
the crankshaft, countershaft and driveshaft rotate smoothly.
* If these shafts do not rotate smoothly, try to free it by tapping
with a plastic hammer.
• Install the gearshift cam stopper.
ENGINE SPROCKET SPACER
• Apply SUZUKI SUPER GREASE to the oil seal lip.
( 99000-25010: SUZUKI SUPER GREASE “A”
• Install the oil seal retainer
1.
• Install the clamp to the bolt
A.
• Apply SUZUKI SUPER GREASE to the O-ring of the engine
sprocket spacer. When installing the engine sprocket spacer
onto the driveshaft, face its grooves
B toward inside.
( 99000-25010: SUZUKI SUPER GREASE “A”
"
NEUTRAL SWITCH
• Install the spring
2, neutral switch contact
3 and O-ring
4.
• Install the neutral switch
5 and plate
6.
"
Use a new O-ring.
Use a new O-ring.
To Next Page
Loading...
