ENGINE 3-53
GENERATOR ROTOR
• Install the cam chain.
• Remove any grease from the tapered portion of the generator
rotor and crankshaft.
• Install the generator rotor key
1.
• Install the generator rotor securely.
• Apply a small quantity of THREAD LOCK SUPER to the gen-
erator rotor nut
2.
) 99000-32030: THREAD LOCK SUPER “1303”
• With the generator rotor locked using the special tool, tighten
the generator rotor nut to the specified torque with a torque
wrench.
% 09930-44530: Rotor holder
# Generator rotor nut: 55 N·m (5.5 kgf-m)
DRIVESHAFT RETAINER
• Install the snap ring
3 to the driveshaft.
"
PRIMARY DRIVE GEAR AND OILPUMP DRIVE GEAR
Install the key
4 onto the crankshaft.
Use a new snap ring.
To Next Page
Loading...
