3-56 ENGINE
CLUTCH
• Install the washer
1 and spacer
2 onto the countershaft.
NOTE:
Apply engine oil to the inside and outside surfaces of the spacer.
• Install the primary driven gear assembly
3 and washer
4
onto the countershaft.
NOTE:
When engaging the primary drive and driven gears, turn the pri-
mary driven gear assembly to the counterclockwise.
• Install the clutch sleeve hub
5 and lock washer
6.
"
1
Primary driven gear assembly
2
Clutch sleeve hub
3
Clutch push rod
4
Clutch driven plate
5
Clutch drive plate
6
Push piece
7
Clutch pressure plate
ITEM N·m kgf-m
A
50 5.0
@
Install the lock washer so that its tongue
A is aligned
with the flat portion of the clutch sleeve hub.
To Next Page
Loading...
