ENGINE 3-55
• Install the gearshift cam driven gear assembly.
• Install the pawl lifter
1 and cam guide
2.
NOTE:
Apply a small quantity of THREAD LOCK to the threads of the
screws.
* 99000-32050: THREAD LOCK “1342”
• Install the return spring
3 to the gearshift shaft
4.
• Install the gearshift shaft.
NOTE:
Align the center teeth on the gearshift shaft with the center teeth
on the gearshift cam driven gear.
OIL PUMP
• Apply engine oil to the sliding surfaces of the oil pump case,
outer rotor, inner rotor and shaft, before mounting the oil
pump.
• Apply a small quantity of THREAD LOCK to the oil pump
mounting screws and tighten them.
* 99000-32050: THREAD LOCK “1342”
• Install the pin
5.
• Install the oil pump driven gear
6 and E-ring
7.
To Next Page
Loading...
