3-68 ENGINE
Camshaft
Pin
Bend up
Bolt
Washer
Sprocket
• Align the arrow marks on the front and rear camshafts so it is
parallel with the surface of the cylinder heads.
NOTE:
Arrow marks are located to forward.
• Engage the chains on the cam sprockets with the locating pin
holes A as shown in the photograph.
NOTE:
Do not rotate the generator rotor while doing this. When the
sprocket is not positioned correctly, turn the sprocket.
• Recheck the position of the “RIT” mark on the generator rotor,
arrow mark on the No.1 (Rear) camshaft and arrow mark on
the No.2 (front) camshaft.
• Install the lock washer so that it is covering the locating pin
• Apply THREAD LOCK SUPER “1303” to the bolts and tighten
them to the specified torque.
# Cam chain sprocket bolt: 15 N
.
m (1.5 kgf
.
m, 11 0 lb-ft)
'99000-32030: THREAD LOCK SUPER “1303”
• Bend up the washer tongue positively to lock he bolts.
CYLINDER HEAD COVER
• Clean the mating surfaces of the cylinder head and head cover
before matching.
• Install the dowel pins to the cylinder head.
Rear (No. 1) cylinder he d
Front (No. 2) cylinder head
Front
Front
To Next Page
Loading...
