6-12 COOLING SYSTEM
INSPECTION
BEARING
• Inspect the play of the bearing by hand while it is in the water
pump case.
• Rotate the inner race by hand to inspect for abnormal noise
and smooth rotation.
• Replace the bearing if there is anything unusual.
MECHANICAL SEAL
• Visually inspect the mechanical seal for damage, with particu-
lar attention given to the sealing face.
• Replace the mechanical seal that shows indications of leak-
age. Also replace the seal ring if necessary.
OIL SEAL
• Visually inspect the oil seal for damage, with particular atten
tion given to the lip.
• Replace the oil seal that shows indications of leakage.
REASSEMBLY AND INSTALLATION
• Install the oil seal.
NOTE:
The stamped mark on the oil seal faces outside.
• Apply a small quantity of the SUZUKI SUPER GREASE “A” to
the oil seal lip.
( 99000-25030: SUZUKI SUPER GREASE “A” (For USA)
99000-25010: SUZUKI SUPER GREASE “A”
(For the others)
To Next Page
Loading...
