VL800/C/TK9 (’09-MODEL) 18-55
THROTTLE VALVE SYNCHRONIZATION
USE OF SDS TOOL
Check and adjust the throttle valve synchronization between two
cylinders.
Step 1
• Lift and support the fuel tank. ( Page 14-93)
• Disconnect the vacuum hoses 1 from the throttle body.
• Connect the respective vacuum tester hoses and IAP sensor
vacuum hoses to each vacuum nipple on the throttle body
with the tools (A, B).
13681-39F00-225: Hose A
13685-02FA0: Three way joint B
Step 2
• Temporary install the fuel tank.
• Set up the SDS tool. (Refer to the SDS operation manual for
further details.)
09904-41010: SDS set tool
99565-01010-017: CD-ROM Ver.17
• Start the engine.
• Click “Data monitor”.
• Warm up the engine (Water temp. more than 90 °C (194 °F)).
To Next Page
Loading...
