18-24 VL800/C/TK9 (’09-MODEL)
DTC TROUBLESHOOTING
“C12” (P0335) CKP SENSOR CIRCUIT MALFUNCTION
On model K9, the connector terminals to be used for checking
sensors for voltage, resistance or continuity at the ECM terminal
are located as shown in the illustration.
* Refer to page 14-46 for details.
“C13” (P1750) or “C17” (P0105) IAP SENSOR CIRCUIT MALFUNCTION
On model K9, the connector terminals to be used for checking
sensors for voltage, resistance or continuity at the ECM terminal
are located as shown in the illustration.
* Refer to page 14-49 for details.
“C14” (P0120-H/L) TP SENSOR CIRCUIT MALFUNCTION
On model K9, the connector terminals to be used for checking
sensors for voltage, resistance or continuity at the ECM terminal
are located as shown in the illustration.
* Refer to page 14-52 for details.
“C15” (P0115-H/L) ECT SENSOR CIRCUIT MALFUNCTION
On model K9, the connector terminals to be used for checking
sensors for voltage, resistance or continuity at the ECM terminal
are located as shown in the illustration.
* Refer to page 14-57 for details.
ECM coupler (Harness side)
ECM coupler (Harness side)
IAP sensor signal #2
IAP sensor signal #1
ECM coupler (Harness side)
ECM coupler (Harness side)
To Next Page
Loading...
