VL800/C/TK9 (’09-MODEL) 18-25
“C21” (P0110-H/L) IAT SENSOR CIRCUIT MALFUNCTION
On model K9, the connector terminals to be used for checking
sensors for voltage, resistance or continuity at the ECM terminal
are located as shown in the illustration.
* Refer to page 14-61 for details.
“C23” (P1651-H/L) TO SENSOR CIRCUIT MALFUNCTION
On model K9, the connector terminals to be used for checking
sensors for voltage, resistance or continuity at the ECM terminal
are located as shown in the illustration.
* Refer to page 14-65 for details.
“C24” (P0351), “C25” (P0352), “C26” (P0353) or “C27” (P0354) IGNITION
SYSTEM MALFUNCTION
[When indicating C24/P0351 for IG coil #1 (main)]
[When indicating C25/P0352 for IG coil #2 (main)]
[When indicating C26/P0353 for IG coil #1 (sub)] ..... E-02, 19, 24, 33 only
[When indicating C27/P0354 for IG coil #2 (sub)] ..... E-02, 19, 24, 33 only
* Refer to the IGNITION SYSTEM for details. ( Page 18-57)
“C28” (P1655) STV ACTUATOR CIRCUIT MALFUNCTION
* Refer to page 14-69 for details.
“C29” (P1654-H/L) STP SENSOR CIRCUIT MALFUNCTION
On model K9, the connector terminals to be used for checking
sensors for voltage, resistance or continuity at the ECM terminal
are located as shown in the illustration.
* Ref
er to page 14-72 for details.
“C31” (P0705) GP SWITCH CIRCUIT MALFUNCTION
* Refer to page 14-78 for details.
ECM coupler (Harness side)
ECM coupler (Harness side)
ECM coupler (Harness side)
To Next Page
Loading...
