18-60 VL800/C/TK9 (’09-MODEL)
COMBINATION METER INSPECTION
LED (LIGHT EMITTING DIODE)
Check that the LED lights (FI indicator light, Oil pressure indicator light and Engine coolant indicator light)
immediately after turning the ignition switch ON. Also, other LED lights (Neutral indicator light, High-beam
indicator light and Turn signal indicator light) can be checked by depending on each switch position.
If the LED fails in operation, replace the combination meter until with a new one after checking its wire har-
ness/coupler.
FUEL LEVEL METER INSPECTION
• Keep the motorcycle upright with a jack or wooden block.
• Release the side-stand or push the side-stand switch.
• Remove the fuel tank. ( Page 14-93)
• Connect the speedometer.
• Connect each resistor between the Y/B and B/W lead wire at
the wire harness.
• Turn the ignition switch “ON” position and wait for approx. 26
seconds.
• Check the display of fuel meter as shown below. If any abnor-
mality is found, replace the speedometer with a new one.
FI
EF
A B
GEAR
Main wiring
harness
B/W
Y/R
B/Lg
Y/B
To fuel pump
Resistor
Resistor
Resistance
Less than
13 Ω
More than 203 Ω
21 – 64 Ω 76 – 115 Ω 129 – 187 Ω
Fuel level
meter
Thermistor OFF OFF OFF OFF OFF ON
Flicker
EFEFEF
EFEF
EF
To Next Page
Loading...
