Suzuki VL800 - Cable Routing

VL800/C/TK9 (’09-MODEL) 18-65
CABLE ROUTING
For E-02, 19, 24, 33
*1
When clamping, locate clutch cable so that its
white tape comes closely adjacent to throttle
cable bracket.
*5
Position the white tape of the clutch cable on
the dent of the frame.
*2
Be careful not to contact the stopper of clamp
and left side cover.
*6
Bring clutch cable into contact with cushion and
clamp it on the rear side of cushion.
*3 Clamp in this direction. *7
Clamp in this direction. Also, put the excess
end of the clamp inside of the seat rail.
*4 Clamp the clutch cable inside of the bar.
UP
Outside
*5
*6
*3
*3
PAIR control
solenoid valve
lead wire
UP
Fuel tank cushion
Outside
High tension cord
Clutch
cable
Clutch cable
Fuel tank
cushion
bar (RH)
Clutch cable
*3
UP
Inside
4
Fuel tank cushion
bar (RH)
Throttle cable No.2
Throttle cable
No.1
0 mm
(0 in)
0 mm
(0 in)
*2
*7
*1
Cable Protector
Guide
Clutch
cable
Throttle cable No.1
Brake hose
Throttle cable No.2
300 mm
(11.8 in)
Throttle cable clip
Wiring harness