ELECTRICAL SYSTEM 8-31
BATTERY
SPECIFICATIONS
Type designation FTX12-BS
Capacity 12V, 36 kC (10 Ah)/10HR
INITIAL CHARGING
FILLING ELECTROLYTE
• Remove the aluminum tape 1 which seals the battery filler
holes 2.
• Remove the caps 3 from the electrolyte container.
NOTE:
* Do not remove or pierce the sealed areas
4
of the electrolyte
container.
* After completely filling the battery with electrolyte, use the caps
3
from the electrolyte container to seal the battery filler holes.
• Insert the nozzles of the electrolyte container 5
into the elec-
trolyte filler holes of the battery Hold the electrolyte container
firmly so that it does not fall Do not allow any of the electrolyte
to spill.
• Make sure the air bubbles rise to the top of each electrolyte
container and leave the electrolyte container in this position for
more than 20 minutes.
To Next Page
Loading...
