ENGINE 3-45
STARTER CLUTCH SERVICING
• Hold the rotor with off-set wrench and remove the starter clutch
securing bolts.
• When fitting the one way clutch to the guide 1, position flange
side A of one way clutch to the rotor side.
• Apply THREAD LOCK SUPER “1303” to the securing bolts and
tighten them to the specified torque while holding the rotor with
off-set wrench.
'99000-32030: THREAD LOCK SUPER “1303”
# Starter clutch securing bolt: 26 N
.
m (2.6 kgf
.
m, 19.0 lb-ft)
OIL PUMP
• Rotate the oil pump by hand and check that it moves smoothly.
• If it does not move smoothly, replace the oil pump assembly.
Do not attempt to disassemble the oil pump assembly.
The oil pump is available only as an assembly.
To Next Page
Loading...
