Suzuki VL800 - MM (5.55 In); MM (5.43 In)

18-62 VL800/C/TK9 (’09-MODEL)
*1 Set the lead wire under the starter relay. *6
Do not contact the plug cap(s) with cylinder
head cover cap.
*2 Set the couplers inside of the frame. *7 Pass the harness inside of the frame.
*3 Set the coupler behind the IG switch body. *8
Pass the lead wire over the engine mounting
bracket.
*4
Pass the HO2 sensor lead wire inside of the
cover.
*9
After connecting the HO2 sensor coupler, set
the coupler in the inside of bracket.
*5
Pass the lead wires under the frame.
Do not contact the lead wires with fuel tank.
*10
Pass the battery - lead wire inside of the
ECM.
To brake
switch,
etc.
To horn
Speedometer
harness
Clamp
Clamp
IAT sensor
Battery
lead wire
Horn
Frame
Wiring harness
Radiator
FWD
Shroud
Tur n
down.
To HO2 sensor
(For E-02, 19, 24, 33)
No use.
Wiring harness
High tension cord
Clamp
Clutch cable
*1
*2
Protector
To HO2 sensor
(For E-02, 19, 24, 33)
For E-03, 28
*4
High tension cord
Clamp
Fuel tank
Frame
*5
*6
Clamp
Clamp
*8
*10
*7
*9
m
– 0
0 – 5 mm
(0.0 – 0.2 in)
TO sensor
Luggage
box plate
Cushion
28 mm
(1.1 in)
0 – 20 mm
(0.0 – 0.8 in)
50 – 80 mm
(2.0 – 3.1 in)