Suzuki VL800 - Reassembly Remounting

CHASSIS 7-45
• Remove the rear brake adjust nut, spring and washer.
• Remove the rear brake link.
• Remove the cotter pins.
REASSEMBLY REMOUNTING
Reassemble and remount the rear brake rod in the reverse order
of removal and disassembly. Pay attention to the fo low ng points.
• Apply grease to the rear brake link pivot bolt and tighten it to
the specified torque.
For USA
# 99000-25030: SUZUKI SUPER GREASE “A”
For the other countries
# 99000-25010: SUZUKI SUPER GREASE “A”
$ Rear brake link pivot bolt: 29 N m (2.9 kgf
.
m, 21 lb-ft)
• Tighten the rear brake pedal mount bolt to the specified torque.
$ Rear brake pedal mount bolt: 11 N
.
m (1.1 kgf
.
m, 8.0 lb-ft)
NOTE:
When remounting the rear brake pedal onto the rear brake pedal
shaft, align the rear brake pedal mounting surface
A with the
punch mark
B .
• Apply grease to the rear brake pedal shaft.
For USA
# 99000-25030: SUZUKI SUPER GREASE “A”
For the other countries
# 99000-25010: SUZUKI SUPER GREASE “A”