3-44 ENGINE
GENERATOR/SIGNAL GENERATOR/ STARTER
CLUTCH
GENERATOR STATOR AND SIGNAL GENERATOR STATOR
INSPECTION&8-8, 19, 20
GENERATOR STATOR AND SIGNAL
GENERATOR STATOR SERVICING
When replacing the generator stator or signal generator stator,
route the wire properly.
STARTER CLUTCH INSPECTION
Install the starter driven gear onto the starter clutch and turn the
starter driven gear by hand to inspect the starter clutch for a
smooth movement. The gear turns one direction only If a large
resistance is felt to rotation, inspect the starter clutch for damage
or inspect the starter clutch contacting surface of the s arter driven
gear for wear or damage.
If they are found to be damaged, replace them with new ones.
STARTER DRIVEN GEAR BEARING INSPECTION
Inspect the starter driven gear bearing for any damages.
To Next Page
Loading...
