Suzuki VL800 - Page 173

COOLING SYSTEM 6-11
• Remove the pin 1 and draw out the impeller shaft 2.
• Remove the mechanical seal ring 3 and rubber seal 4.
• Remove the bearing with the special tool.
& 09921-20220: Bearing remover set
NOTE:
If no abnormal noise, bearing removal is not necessary.
!
The removed bearing must be replaced with a new one.
• Remove the mechanical seal with the special tool.
& 09921-20220: Bearing remover set
NOTE:
If no abnormal noise, bearing removal is not necessary.
!
The removed mechan cal seal must be replaced with a
new one.
• Remove the oil seal with a suitable bar.
NOTE:
If no abnormal, the oil seal removal is not necessary.
!
The removed oil seal must be replaced with a new one.