SHAFT DRIVE 4-9
REASSEMBLY
SECONDARY DRIVEN BEVEL GEAR
• Apply grease to the lip of oil seal.
& 99000-25030: SUZUKI SUPER GREASE “A” (For USA)
99000-25010: SUZUKI SUPER GREASE “A”
(For the others)
• Tighten the bearing stopper to the specified torque with the
special tool.
! Bearing stopper: 105 N
.
m (10.5 kgf
.
m, 76.0 lb-ft)
# 09921-21820: Bearing retainer wrench
SECONDARY DRIVE BEVEL GEAR
Reassemble the secondary drive bevel gear in the reverse order
of disassembly. Pay attention to the following points.
• When installing a new circlip, pay attention to the direction of
the circlip. Fit the circlip to the side where the thrust is, as shown
in the illustration. The rounded side should be against the out-
put cam dog surface.
$
* Never reuse a circlip. After a circlip has been removed
from a shaft, it should be discarded and a new circlip
must be installed.
* When installing a new circlip, do not expand the end
gap larger than required to slip the circlip over the shaft.
* After installing a circlip make sure that it is completely
seated in its groove and securely fitted.
INSTALLATION
SECONDARY DRIVEN BEVEL GEAR/
SECONDARY DRIVE BEVEL GEAR
• Refer to the engine reassembly sections.
Engine reassembly "3-53
Thrust
Sharp edge
To Next Page
Loading...
