4-12 SHAFT DRIVE
FINAL GEAR CASE REMOVAL
After draining final gear oil, the following components must be
removed in the described order before removing the final gear
case.
NOTE:
Refer to the following pages for the details of each step.
• Drain final gear oil. ("2-15)
• Remove the rear wheel. ("7-38)
FINAL GEAR CASE DISASSEMBLY
• Remove the plate 1.
• Remove the oil seal 2.
$
The removed oil seal must be replaced with a new one.
• Remove the circlip with the special tool and take off the propel-
ler shaft and spring.
# 09900-06108: Snap ring pliers
• Remove the final gear case.
To Next Page
Loading...
