5-22 FUEL AND LUBRICATION SYSTEM
45˚
FLOAT HEIGHT ADJUSTMENT
• Measure the float height A by using a calipers with the carbu-
retor slanting at an angle of 45° (as shown in the right illustra-
tion) and the float arm just contacting the needle valve.
• Bend the tongue B of the float arm as necessary to bring the
height A to the specified value.
& Float height A: 7.0 ± 0.5 mm (0.28 ± 0.02 in)
$ 09900-20102: Vernier calipers
To Next Page
Loading...
