FUEL AND LUBRICATION SYSTEM 5-25
THROTTLE POSITION SENSOR POSITIONING
• Install the throttle position sensor with the flats on the throttle
shaft end securely engaged with the slot on the throttle posi-
tion sensor.
• Measure the resistance between the throttle position
sensor terminals as shown in the illustration.
& Throttle position sensor resistance : Approx. 5 kΩ
• Measure the resistance between the throttle position
sensor terminals as shown in the illustration.
• Fully open the throttle valve with the throttle lever.
• Position the throttle position sensor until resistance is 3.09
– 4.63 kΩ.
• When the resistance is within specification, tighten the
throttle position sensor mounting screws.
& Throttle position sensor resistance :
3.09 – 4.63 k
Ω
Ω
• After the assembly and installation on the engine have been
completed, perform the following adjustment.
* Throttle cable adjustment (" 2-11)
* Idle speed adjustment (" 2-10)
Ω
1
Ω
2
Ω 1
Ω 2
Ω 1
Ω 2
Ω 2
Ω 2
CARBURETOR HEATER
• Apply thermo-grease to the threads and tighten the carburetor
heater. (for E-02, 19)
) 99000-59029: THERMO GREASE
* Carburetor heater: 3 N
.
m (0.3 kgf
.
m)
To Next Page
Loading...
