7-34 CHASSIS
Forward
Punch mark
Clearance
HANDLEBARS
• When setting the handlebar clamp to the handlebar holder of
the steering upper bracket, face the punched mark A on its
clamp forward.
• First, tighten the handlebar clamp bolts 1 to the half of speci-
fied torque, and then tighten the handlebar clamp bolts 1 and
2 to the specified torque.
$ Handlebar set bolt: 23 N
.
m (2.3 kgf
.
m, 16.5 lb-f )
• Install the handlebar set bolt cap.
• Apply grease to the throttle cable end
For USA
# 99000-25030: SUZUKI SUPER GREASE “A”
For the other countries
# 99000-25010: SUZUKI SUPER GREASE “A”
• Install the handlebars with the punch mark B aligned with the
handlebar clamp as shown.
• Install the front brake master cylinder. ('7-17)
$ Front master cylinder mounting bolt: 10 N
.
m
(1.0 kgf
.
m, 7.0 lb-ft)
To Next Page
Loading...
