7-50 CHASSIS
INSPECTION AND DISASSEMBLY
SPACER
• Remove spacer from swingarm.
• Remove the spacers from the cushion lever.
• Inspect the spacers for any flaws or other damage. If any de-
fects are found, replace the spacers with new ones.
SWINGARM BEARING
Insert the spacer into swingarm cushion rod upper side bearing
and check the play to move the spacer up and down.
If excessive play is noted, replace the bearing with a new one.
Inspect the swingarm pivot bearing, its race and dust seal for
wear or damage. If any defects are found, replace the bearing
with a new one.
• Remove the swingarm pivot right side bearing plate 1 and bear-
ing races 2 by using a suitable bar and so on.
NOTE:
The swingarm pivot right side bearing and its plate are available
as one component.
• Remove the swingarm pivot bearing races by using the special
tools.
" 09921-20220: Bearing remover set (30 mm)
!
The removed bearings must be replaced with new ones.
• Remove the swingarm cushion rod upper side bearing by us-
ing the special tools.
" 09921-20220: Bearing remover set (17 mm)
!
The removed bearings must be replaced with new ones.
To Next Page
Loading...
