7-52 CHASSIS
REASSEMBLY
Reassemble the swingarm and shock absorber in the reverse
order of disassembly and removal, and pay attention to the fol-
lowing points:
SWINGARM BEARING
• Install the swingarm pivot bearing races by using the special
tool.
" 09913-70210: Bearing installer set (40 mm)
NOTE:
The swingarm pivot bearing race with plate is positioned right
side.
• Install the swingarm cushion rod upper side bearing with the
special tool.
" 09924-84521: Bearing installer set
NOTE:
When reinstalling the bearing, stamped mark of bearing must
face outside.
CUSHION LEVER BEARING
• Install the bearings into the cushion lever by using the special
tool.
" 09924-84521: Bearing installer
NOTE:
When installing the bearings, stamped mark of bearing must face
outside.
• Apply grease to the spacers and bearings
For USA
# 99000-25030: SUZUKI SUPER GREASE “A”
For the other countries
# 99000-25010: SUZUKI SUPER GREASE “A”
• Assemble the shock absorber, cushion lever and cushion rods
onto the swingarm. ('7-47)
$ Shock absorber mounting nut 1: 50 N
.
m
(5.0 kgf
.
m, 36.0 lb-ft)
Cushion rod mounting nut 2: 78 N
.
m
(7.8 kgf
.
m, 56.5 lb-ft)
NOTE:
The stamped marks
A
on the cushion rod should be face out-
side.
To Next Page
Loading...
