ELECTRICAL SYSTEM 8-15
TURN SIGNAL/SIDE-STAND RELAY
The turn signal/side-stand relay is composed of the turn signal
relay, and the side-stand relay and diode.
• Remove the secondary gear case cover.
• Remove the turn signal/side-stand relay.
SIDE-STAND RELAY INSPECTION
First check the insulation between D and E terminals with the
tester. Then apply 12V to terminals D and C (+ to D and -
to C) and check the continuity between D and E. If there is no
continuity, replace the turn signal/side-stand relay with a new one.
DIODE INSPECTION
Measure the voltage between the terminals using the multi circuit
tester. Refer to the following able.
More than 1.4 V
(Tester's battery voltage)
V
" 09900-25008: Multi circuit tester set
$ Tester knob indication: Diode test (
%
%)
NOTE:
If the multi circuit tester reads under 1.4V when the tester probes
are not connected, replace its battery.
To Next Page
Loading...
