ELECTRICAL SYSTEM 8-17
Measure the battery voltage between
input lead wires (O/W and B/W) at the
ignitor with the ignition switch in the Incorrect • Faulty ignition switch
“ON” position. • Faulty turn signal/side-stand
relay
• Faulty engine stop switch
Correct • Broken wire harness or poor
connection of related circuit
couplers
Measure the ignition coil primary peak
voltage. (& 8-18) Inspect the spark plugs.
NOTE: The ignition coil peak voltage
Correct
(& 2-5)
inspection method is applicable only
with the multi circuit tester and the peak
volt adaptor.
Correct Incorrect
Incorrect
• Faulty spark plug (-s)
• Improper spark plug
connection
Inspect the ignition coils. (& 8-19)
Incorrect
• Faulty ignition coil (-s)
Correct
Measure the pickup coil peak voltage
and resistance. (& 8-19, -20)
NOTE: The pickup coil peak voltage
Incorrect • Faulty pickup coil
inspection is applicable only with
the
multi circuit tester and peak volt adaptor.
Correct
• Faulty ignitor
• Faulty wire harness
• Improper ignition
coupler connection.
To Next Page
Loading...
