8-22 ELECTRICAL SYSTEM
PARTS NAMES
1 High beam indicator light
2 Engine coolant temperature
indicator light
3 Turn signal indicator light
4 Oil pressure indicator light
5 Neutral indicator light
6 Fuel level meter
7 Speedometer/tripmeter/clock
8 SELECT button
9 ADJUST button
OPERATING PROCEDURE
INITIAL DISPLAY
When the ignition switch is set to ON, all LCD light up for three
seconds.
NOTE:
If the power supply is cut (e, g, when the battery is replaced):
* The odometer, tripmeter and clock are displayed after the ini-
tial display appears.
* Since the clock resets to “1:00”, it will need to be readjusted.
CHANGE THE DISPLAY MODE
With each press of the SELECT button, the display changes be-
tween odometer, tripmeter A, tripmeter B and clock as shown.
)
To avoid riding with on y one hand, do not operate the
buttons while riding.
ODOMETER
• Displays the total distance travelled.
TRIPMETER
• Displays the distance travelled since the tripmeter was last re-
set.
NOTE:
The tripmeters A and B can be used independently.
• Hold down the ADJUST button for two seconds to reset the
tripmeter.
Odometer ClockTripmeter A Tripmeter B
To Next Page
Loading...
