2-16 PERIODIC MAINTENANCE
BRAKE LIGHT SWITCH
• Adjust the rear brake light switch so that the brake light will
come on just before pressure is felt when the brake pedal is
depressed.
REAR BRAKE PEDAL HEIGHT
• Loosen the lock nut 1.
• Adjust the brake pedal height A by turning the adjuster 2.
" Rear brake pedal height : 75 – 85 mm
REAR BRAKE ADJUSTING
• Adjust the free travel B to 20 – 30 mm by turning the adjusting
nut 3.
" Rear brake pedal free travel B: 20 – 30 mm
REAR BRAKE SHOE WEAR
This motorcycle is equipped with brake lining wear limit indicator
on the rear brake.
To check brake lining wear, perform the following steps.
• Make sure that the rear brake is properly adjusted.
• Depress the rear brake pedal Make sure that the index mark
4 is within the range 5 embossed on the brake panel.
• If the index mark goes beyond the range, the brake shoe as-
sembly should be replaced with a new set of shoes.
To Next Page
Loading...
