14-106 VL800K5 (’05-MODEL)
• Remove the STP sensor
8 with the special tool.
" 09930-11950: Torx wrench
NOTE:
* Prior to disassembly, mark the STP sensor’s original position
with a paint or scribe for accurate reinstallation.
* TP sensor and STP sensor look very much alike. To avoid
confusion, mark identifications when removing.
#
#
#
• Remove the fuel delivery pipes
E.
Never remove the STVA
9 from the throttle body.
* Do not loosen the nut
0.
* Do not turn the screw
A.
* The fast idle screw
B is factory-adjusted at the time
of delivery and therefore avoid removing or turning it
unless otherwise necessary.
Never remove the secondary throttle valve
C and
throttle valve
D.
To Next Page
Loading...
