ENGINE 3-13
• Remove the cylinder head bolt and nut. (Rear cylinder)
• Push the cam chain tension adjuster rod and insert the special
tool.
% 09918-53810: Chain tensioner lock tool
• Remove the cylinder head by removing the cylinder head bolts.
• Remove the water hose and pipe.
• Remove the cylinder. (Rear cylinder)
PISTON
• Place a clean rag under the piston to prevent any parts from
falling into the clankcase.
• Remove the piston pin circlip 1 using long-nose pliers.
• Draw out each piston pin and remove the pistons.
NOTE:
Scribe the cylinder position on the head.
To Next Page
Loading...
