Suzuki VL800 - Page 559

VL800/C/TK9 (’09-MODEL) 18-19
ECM TERMINAL
TERMINAL
NO.
CIRCUIT
TERMINAL
NO.
CIRCUIT
1 GP switch signal (GP) H —
2 IAT sensor signal (IAT) I ECT sensor signal (ECT)
3 IAP sensor signal #2 (IAP. F) J TO sensor signal (TOS)
4 STP sensor signal (STP) K TP sensor signal (TP)
5 Power source for sensors (VCC) L IAP sensor signal #1 (IAP. R)
6
HO2 sensor signal #2 (HO2S. F)
[For E-02, 19, 24, 33]
M —
7 Clutch lever position switch (CLT) N —
8 CKP sensor signal (CKP–) O Starter switch signal
9 Power source for fuel injectors (VM) P Neutral switch signal
0 Power source for back-up Q CKP sensor signal (CKP+)
A Power source R Mode select switch
B Sensor ground (E2) S —
C ECM ground (E1) T —
D — U Serial data for speedometer (TECH)
E — V Serial data for self-diagnosis
F — W
HO2 sensor signal #1 (HO2S. R)
[For E-02, 19, 24, 33]
G
HO2 sensor heater (HO2. H)
[For E-02, 19, 24, 33]
X Fuel pump relay (FP Relay)
TERMINAL
NO.
CIRCUIT
TERMINAL
NO.
CIRCUIT
Y STVA signal (STVA. 1B) d STVA signal (STVA. 2B)
Z
EVAP system purge control solenoid
valve (EVAP) [E-33 only]
e
PAIR control solenoid valve
(PAIR)
[ STVA signal (STVA. 1A) f STVA signal (STVA. 2A)
\ ISC signal (ISC. 2B) g ISC signal (ISC. 1A)
]
Ignition coil #2 (sub)
[For E-02, 19, 24, 33]
h
Ignition coil #1 (sub)
[For E-02, 19, 24, 33]
^ ISC signal (ISC. 1B) i ISC signal (ISC. 2A)
a Ground j Ground
b Fuel injector #1 (#1) k Fuel injector #2 (#2)
c Ignition coil #1 (main) l Ignition coil #2 (main)