18-42 VL800/C/TK9 (’09-MODEL)
THROTTLE BODY DISASSEMBLY
• Remove the fuel feed hose 1.
• Remove the clamp 2.
• Loosen the screw and remove the plate 3.
• Pull on the straight plug 4 straightly outward to remove it so
as not to cause scratches on the O-ring seat of the delivery
pipe.
• Screw an appropriate bolt with the size of M5 × 0.8 into the
straight joint 5 at least ten turns (8 mm).
• Pull on the straight joint 5 straightly outward to remove it so
as not to cause scratches on the O-ring seat of the delivery
pipe.
• Loosen screws and remove the delivery pipe 6 straightly out-
ward so as not to cause scratches on the fuel injector.
To Next Page
Loading...
