VL800/C/TK9 (’09-MODEL) 18-45
THROTTLE BODY CLEANING
• Clean all passageways with a spray-type carburetor cleaner
and blow dry with compressed air.
THROTTLE BODY INSPECTION
• Check following items for any damage or clogging.
*O-ring
* Throttle valve
* Secondary throttle valve
* Vacuum hose
* Fuel hose/pipe
* Injector cushion seal
Some carburetor cleaning chemicals, especially dip-
type soaking solutions, are very corrosive and must
be handled carefully. Always follow the chemical man-
ufacturer’s instructions for proper use, handling and
storage.
Do not use wire to clean passageways. Wire can dam-
age passageways. If the components cannot be
cleaned with a spray cleaner it may be necessary to
use a dip-type cleaning solution and allow them to
soak. Always follow the chemical manufacturer’s
instructions for proper use and cleaning of the throttle
body components. Do not apply carburetor cleaning
chemicals to the rubber and plastic materials.
To Next Page
Loading...
