VL800/C/TK9 (’09-MODEL) 18-89
• Remove the EVAP system purge control solenoid valve 5
from the purge control solenoid valve bracket.
NOTE:
EVAP system purge control solenoid valve can be checked with-
out removing it. (Page 18-38)
INSPECTION
• Check that no air flows through both of the air inlet and outlet
ports.
• If air flows out, replace the EVAP system purge control sole-
noid valve with a new one.
• Connect 12 V battery to the terminals of the EVAP system
purge control solenoid valve and check the air flow.
• If air flows out, the solenoid valve is in normal condition.
• Check the resistance between the terminals of the EVAP sys-
tem purge control solenoid valve.
EVAP system purge control solenoid valve resistance:
Approx. 32 Ω at 20 °C (68 °F)
09900-25008: Multi-circuit tester set
Tester knob indication: Resistance (Ω)
• If the resistance is not within the standard range, replace the
EVAP system purge control solenoid valve with a new one.
INSTALLATION
Installation is in the reverse order of removal. Pay attention to
the following point:
• Connect the purge control solenoid valve coupler and canister
hoses securely. (Page 18-92)
To Next Page
Loading...
