ENGINE 3-27
VALVE GUIDE SERVICING
• Using the valve guide remover, drive the valve guide out to-
ward the intake or exhaust rocker arm side.
% 09916-44910: Valve guide remover/installer
NOTE:
* Discard the removed valve guide subassemblies.
* Only oversized valve guides are available as replacement parts.
(Part No. 11115-38A71)
• Re-finish the valve guide holes in cylinder head with a 10.8 mm
reamer and handle.
% 09916-34580: Valve guide hole reamer
09916-34542: Reamer handle
• Oil the stem hole, too, of each valve guide and drive the gu de
into the guide hole with the valve guide installer and attach-
ment.
% 09916-44910: Valve guide remover/insta ler
09916-44920: Valve guide installer attachment
&
Failure to oil the valve guide hole before driving the new
guide into place may result in a damage guide or head.
• After fitting all valve guides, re-finish their guiding bores with a
5.5 mm reamer. Be sure to clean and oil the guide after ream-
ing.
% 09916-34550: Valve guide reamer
09916-34542: Reame handle
NOTE:
Insert the reamer from the combustion chamber and always turn
the reamer handle clockwise.
Valve
guide
Cylinder
head
To Next Page
Loading...
