Prior to Installation Site Preparations
DOC-001-11001 (Rev. 006) 2 DNX Quick Install & Setup Guide
Site Preparations
Before you install the DNX, contact your service provider to ensure that the proper transmission
equipment and lines are installed. For LAN-based network management applications, the site
must have at least one 10BaseT Ethernet network in place. Depending upon the application
being supported, you may also need dial-in telephone lines.
Required Tools and Cables
• Basic Telecommunications installation tool kit including flat and Phillips-head screwdrivers,
wire strippers, etc.
• Rack mounting hardware including screws and washers
• Craft port cable
• Interface cables
• Optional: Volt-Ohm Meter (VOM)
Site Environmental Recommendations
When selecting a site to install the equipment, choose a protected area in an environment that
is:
• Temperature regulated
• Humidity controlled
• Isolated from large motors and heating units
To Next Page
Loading...