PSX-5300 Installation PSX Module Installation and Cable Connection
DOC-001-11001 (Rev. 006)
33 DNX Quick Install & Setup Guide
Broadband Cable Connections
1. Connect the RX BNC cable from the network to the "IN" RX jack on the PSX Broadband
Primary module and the TX BNC cable to the network to the "IN" TX jack.
2. Connect one of the BNC attachment cables (part # CBE-002-75015) between the PSX
Primary "OUT" TX and the RX port of the corresponding broadband interface module in the
DNX.
3. Connect another BNC attachment cable (part # CBE-002-75015) between the PSX Primary
"OUT" RX and the TX port of the corresponding broadband interface module in the DNX.
4. Connect another BNC cable (part # CBE-002-75015) between the RX port of the PSX
Broadband Redundant module and the TX port of the corresponding back-up broadband
interface module in the DNX.
5. Connect another BNC cable (part # CBE-002-75015) between the TX port of the PSX
Broadband Redundant module and the RX port of the corresponding back-up broadband
interface module in the DNX.
Figure 26 on the following page illustrates a PSX connection for Broadband Redundancy.
To Next Page
Loading...
