097-58001-01 Revision E – September 2006 TimeProvider TL1 Reference Guide 101
Chapter 2 TL1 Command Syntax and Description
Retrieve Equipment (RTRV-EQPT)
Retrieve Equipment (RTRV-EQPT)
This command retrieves currently provisioned equipment parameters.
This command has a default access level of USER.
Syntax
RTRV-EQPT:[<tid>]:<aid>:[<ctag>]::<keyword>;
Note:
See
Edit Equipment (ED-EQPT)
, on page 45 for <keywords>
and descriptions of their possible <values>.
Parameter Value Description
<aid> SYS Equipment settings for system-level.
COMp
Equipment settings for the communication port specified by p:
p = “L” for the local serial port
p = “R” for the remote serial port
p = “I” for the IP (Ethernet) port
IOCm Equipment settings for the IOC module specified by m:
m = “1” for the slot marked “IOC 1" on the main shelf
m = “2” for the slot marked “IOC 2" on the main shelf
GPS Equipment settings for the GPS system input.
PRS Equipment settings for the PRS system input.
INPp Equipment settings for the input port specified by p:
p = “1” for the input marked INP 1 on the Input Connector
module
p = “2” for the input marked INP 2 on the Input Connector
module
OUTg Equipment settings for the output group specified by g:
g = “A” for the group marked “A” on the main shelf
g = “B” for the group marked “B” on the main shelf
g = “C” for the group marked “C” on the main shelf
g = “D” for the group marked “D” on the main shelf
E422g Equipment settings for the EIA-422 output group specified by
g:
g = “A” for the group marked “A” on the main shelf
g = “B” for the group marked “B” on the main shelf
g = “C” for the group marked “C” on the main shelf
g = “D” for the group marked “D” on the main shelf
To Next Page
Loading...
Need help?
General
